Subject	its upside down but its right (n/m)
Posted by	LoweBudget(Central VA) on February 28, 2006 at 2:41 PM
	This message has been viewed 33 times.
In Reply To	This picture is an original panel, hard to say if thats posted by CaliguyPurdue on February 28, 2006 at 02:33 PM
Message
Follow Ups	J-spec nose panel- exact emblem location? - CaliguyPurdue 14:08:20 02/28/06 take two pieces of string and go from top left corner - LoweBudget(Central VA) 14:16:13 02/28/06 So are you confirming that x.xx = y.yy? (n/m) - CaliguyPurdue 14:26:27 02/28/06 thats what I did (n/m) - drmx 14:33:03 02/28/06 This picture is an original panel, hard to say if thats - CaliguyPurdue 14:33:56 02/28/06 its upside down but its right (n/m) - LoweBudget(Central VA) 14:41:49 02/28/06 Great thanks! (n/m) - CaliguyPurdue 14:44:47 02/28/06 I'm with you - it doesn't look like x.xx would = y.yy. (n/m) - Scotts94z32 15:20:20 02/28/06 According to Photoshop, - TT XTZ 15:36:01 02/28/06 Thanks for checking that, although look at this... - CaliguyPurdue 15:57:39 02/28/06 Serious question: Why put all this effort to locate the - Dave N 16:09:01 02/28/06 Good question. Short answer, I'm OCD. - CaliguyPurdue 16:14:11 02/28/06 I'd leave the emblem off anyway *Shrug* (n/m) - Scotts94z32 16:17:50 02/28/06 Big 2nd. If it isn't off center, it'll be slightly rotated a - Dave N 17:04:45 02/28/06 Exactly. I measured with a tape measure and marked w/ tape - Z-Jay (Edmonton, AB) 16:17:32 02/28/06 According to my stock '93 nosepanel: - Di Lo 17:29:10 02/28/06 In a photoworld when you matte something you want to... - mkieferdotnet 21:56:20 02/28/06 yes (n/m) - LoweBudget(Central VA) 14:31:38 02/28/06 Whatever you do, don't put it upside down. (n/m) - YugoBernie (NoVA) 15:19:34 02/28/06 Seriously. - SeedyROM 15:36:22 02/28/06 back in the box to return it... - Spee 15:34:36 02/28/06 2nd (n/m) - ENVYMYZ 15:47:38 02/28/06 Thanks Spee but it was packaged in a baggie :) (n/m) - CaliguyPurdue 15:59:27 02/28/06 meh... (n/m) - Z-Jay (Edmonton, AB) 16:14:33 02/28/06
Post a Followup	You cannot reply to this message because you are not logged in.