TwinTurbo.NET: Nissan 300ZX forum - There's a good reason for that
People Seeking Info
 
   


     
Subject There's a good reason for that
     
Posted by jkeyser14 on February 22, 2006 at 9:28 AM
  This message has been viewed 26 times.
     
In Reply To I will for sure. posted by Rule12b on February 21, 2006 at 07:12 PM
     
Message It's easier to replace to a piston than the block if one of the tolerances happens to be off. Besides, it's much easier to machine OD's to exact tolerances than it is ID's.



     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.