TwinTurbo.NET: Nissan 300ZX forum - Re: I will for sure.
People Seeking Info
 
   


     
Subject Re: I will for sure.
     
Posted by bankruptedz on February 21, 2006 at 7:25 PM
  This message has been viewed 37 times.
     
In Reply To I will for sure. posted by Rule12b on February 21, 2006 at 07:12 PM
     
Message :I think it is interesting that Specialty preps the block first, then sends individual cylinder measurements to Ross who then manufactures the pistons to those individual specs for the best possible tolerances (within reason I'm sure).
:Waiting for the pistons slowed up the build a bit, but it just gave me time to save up more $$$ so I can't complain.

Which is a complete waste of time - if you over bore it's just as easy to hit the tolerences on the block side. Different size pistons will swell to different sizes under heat - not a good thing. Better to have the same size slugs and alter the bore to them - if needed.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.