Subject	Drilled and tapped hole in recir valve put fitting
Posted by	MikeH(Phoenix) on April 18, 2001 at 8:05 AM
	This message has been viewed 20 times.
In Reply To	how did you do this???I don't like having that hose>> posted by Russ ZTT (Jax, Fl) on April 18, 2001 at 06:05 AM
Message	JamieZx posted picture last month. Mike Dynoed 400 RWHP @ 19 psi 384 RWHP @ 17psi On Stock Turbos. Dynoed 515 rwhp and 420 ft.lbs @ 16psi 89 degrees. 533 rwhp and 450 ft. lbs @19 psi and slipping clutch and heat soaked motor , 85 degrees.
Follow Ups	Some new toys for under the hood, *warning* large pics - Tsao 00:12:51 04/18/01 Whats with the connector between the intake hoses? (n/m) - ZX NAT (Dallas) 00:23:06 04/18/01 Its a balance tube >>> - Tsao 00:32:06 04/18/01 hmm, so could I "build" this into my stock pipes> - ZX NAT (Dallas) 00:35:40 04/18/01 If you have dual pop charger you can do what i did - MikeH(Phoenix) 00:44:52 04/18/01 Well, since I'm a lowly N/A'er... Afraid thats not possibe.. (n/m) - ZX NAT (Dallas) 00:47:28 04/18/01 how did you do this???I don't like having that hose>> - Russ ZTT (Jax, Fl) 06:05:57 04/18/01 Drilled and tapped hole in recir valve put fitting - MikeH(Phoenix) 08:05:47 04/18/01 thats what I did but the hose goes to that hardpipe along>> - Russ ZTT (Jax, Fl) 11:41:17 04/18/01 Well, it still goes to that hardpipe >>> - Spooled 12:33:52 04/18/01 looks neat but not needed... - TARGETZ 07:21:30 04/18/01 Looks good man but>>>> - Jeff(SC) 00:41:33 04/18/01 ya hook us up!!, teaser!!! (n/m) - three hun net (CA) 02:23:41 04/18/01 Wow, that is beautiful. I'll buy your hks bov's :) - StoMoZTT 00:57:31 04/18/01 set us up with a GB, please? ^^ (n/m) - FLY 1 (Dallaz) 01:05:15 04/18/01 Polish your plenum! It will look sweet!!! I'm in on GB> >>> - AshsZ (In Florida) 06:30:37 04/18/01
Post a Followup	You cannot reply to this message because you are not logged in.