Subject	That is a high pressure area. Not a good idea to remove.
Posted by	RSR on February 17, 2006 at 9:45 AM
	This message has been viewed 28 times.
In Reply To	Thinking of modding the hood so more heat comes out. posted by upcominZ_NA>TT on February 16, 2006 at 10:20 PM
Message	Vented hoods should be vented near the front of the hood. The base of the windshield is a high pressure area, and air will enter the engine bay at that location, rather than exit the engine bay. I would not recommend this modification.
Follow Ups	Thinking of modding the hood so more heat comes out. - upcominZ_NA>TT 22:20:17 02/16/06 Re: Thinking of modding the hood so more heat comes out. - zboost(tx) 22:24:23 02/16/06 in the rain though, wouldnt rain roll into the engine there? (n/m) - Rickytl (MA) 22:34:05 02/16/06 a guy from a different forum - ARA300ZX 22:55:00 02/16/06 no. there is a metal lip that holds the rubber up. - upcominZ_NA>TT 22:38:19 02/16/06 >>>>> - CollegeBoy 22:46:44 02/16/06 did he also say something about low pressure area and - CHUNG (Dallas) 23:13:00 02/16/06 instability? how fast would you have to be going? (n/m) - upcominZ_NA>TT 23:43:32 02/16/06 i remove it and tuck it between the eng and wall (n/m) - SpecNATT (Houston) 23:34:09 02/16/06 That is a high pressure area. Not a good idea to remove. - RSR 09:45:49 02/17/06 Re: Thinking of modding the hood so more heat comes out. - ni[X]it 10:56:30 02/17/06 shadetree (n/m) - RSR 13:45:34 02/17/06 Re: Thinking of modding the hood so more heat comes out. - canyoncarver 13:57:20 02/17/06
Post a Followup	You cannot reply to this message because you are not logged in.