Subject	ouch
Posted by	CollegeBoy on February 14, 2006 at 4:25 PM
	This message has been viewed 28 times.
In Reply To	My body shop did it against my orders. I will let you know posted by CaliguyPurdue on February 14, 2006 at 02:51 PM
Message	It'll crack. All well...since they did it without you wanting them too maybe you could have them fix it for free. Rivets, bondo, and urethane all expand differently with temp changes. That alone will cause them to crack eventually, but with the stresses of wind in the front of your car and if you ever bottom out a little which we all do, it will greatly speed up this process. Thanks, Mike 1991 Black Twin Turbo (Show AND Go) If you give two crappers,then this is about me... La-Z-Link ^^Link made special just for member GoldZ =)^^ "lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z "I think I'll pass on giving my car a handjob" - joel(PA) "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21 "If I wanted a smooth ride, I would have bought a Lincoln."
Follow Ups	I'm considering moulding my Stillen front lip to my my stock - Di Lo 13:24:09 02/14/06 I have heard of a lot of people experiencing cracking.... - KevinsFairlady 13:59:15 02/14/06 i agree...i believe if u bottom out, your probably gonna - Atl300zxTT 14:49:02 02/14/06 My body shop did it against my orders. I will let you know - CaliguyPurdue 14:51:26 02/14/06 that sucks, i give it 1 month if ur careful - Atl300zxTT 14:55:14 02/14/06 Re: that sucks, i give it 1 month if ur careful - aquariuscsm 17:14:43 02/14/06 ouch - CollegeBoy 16:25:58 02/14/06 yea i was considering the thermal expansion thing too. - CaliguyPurdue 17:24:48 02/14/06 I never like the look of molded body pieces. Wide bodies - rufflez 15:27:00 02/14/06 2nd it makes the car too smooth (n/m) - CollegeBoy 16:26:38 02/14/06 Wha...? You've had TD05's all this time and stock ICs? (n/m) - Z-Jay (Edmonton, AB) 16:38:16 02/14/06
Post a Followup	You cannot reply to this message because you are not logged in.