TwinTurbo.NET: Nissan 300ZX forum - Scared myself. Just finished installing an ASP pulley,
People Seeking Info
 
   


     
Subject Scared myself. Just finished installing an ASP pulley,
     
Posted by 240Z FeO2 on February 12, 2006 at 7:52 PM
  This message has been viewed 392 times.
     
     
Message relocating PTU and replacing 4 coilpack connectors. Started up the car and it didn't sound quite right. It had been idling a little rough at start up recently, but would smooth out in short order, so I pressed on.

After about 5 miles it sounded to my untrained ears that the car was not running on all cylinders; putt putting on acceleration rather than revving smoothly. Drove back home, rather depressed, and pulled into the garage. Rolled down the window with the motor still running (no I wasn't contemplating suicide), and yep it sounded like crap and never like I had heard it before.

Obviously the CCP and PTU were implicated here. Popped the hood. Sure enough, I had failed to insert the center DS connector all the way into the coilpack. Did so. Fired it back up. Smoothness returned and of course I couldn't resist taking it back out for a few miles now that my TT was back to normal.

Life is good.

Image hosting by Photobucket

Oh ya. Found the UD pulley beneficial. Definitely increased power and responsiveness when accelerating from a stop, and a bit quicker revving at higher rpms, also.

:-)

:-)

Image hosting by Photobucket

Chance favors the informed.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.