TwinTurbo.NET: Nissan 300ZX forum - Once again, I've never had to do it
People Seeking Info
 
   


     
Subject Once again, I've never had to do it
     
Posted by CollegeBoy on February 12, 2006 at 1:37 PM
  This message has been viewed 26 times.
     
In Reply To I have heard of people using these to get them off posted by CollegeBoy on February 12, 2006 at 01:34 PM
     
Message I've just heard abotu it,and I also think you'd need a larger size than the 19mm that comes in that set I just showed. After seeing how easily they removed my circular stripped bolts though, I'm sure they could take off your wheel locks with ease. Just need to find the right size.

Thanks,
Mike
1991 Black Twin Turbo (Show AND Go)

If you give two crappers,then this is about me...
La-Z-Link
^^Link made special just for member GoldZ =)^^

"lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z
"I think I'll pass on giving my car a handjob" - joel(PA)
"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21
"If I wanted a smooth ride, I would have bought a Lincoln."

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.