TwinTurbo.NET: Nissan 300ZX forum - I have heard of people using these to get them off
People Seeking Info
 
   


     
Subject I have heard of people using these to get them off
     
Posted by CollegeBoy on February 12, 2006 at 1:34 PM
  This message has been viewed 92 times.
     
In Reply To U ARE RIGHT Re: You mean you have wheel locks and posted by tian2bing on February 12, 2006 at 01:30 PM
     
Message Supposedly it will work from what I've heard. They are made to get off stripped bolts and work AWESOME with those, so I'm sure with the right size, a little patience, and tapping them onto the nut, it should work. Just replace the nuts once removed obviously.

Here's some pics of my metric set. I got it from Home Depot.

Thanks,
Mike
1991 Black Twin Turbo (Show AND Go)

If you give two crappers,then this is about me...
La-Z-Link
^^Link made special just for member GoldZ =)^^

"lmao, i know, theres more drama and favoritism on tt.net than a middle school girls locker room" - sfpearl300z
"I think I'll pass on giving my car a handjob" - joel(PA)
"I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - DC 21
"If I wanted a smooth ride, I would have bought a Lincoln."

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.