Subject	I know
Posted by	zboost(tx) on February 09, 2006 at 1:51 PM
	This message has been viewed 23 times.
In Reply To	do not use it as a means to verify for boost/vacuum leaks posted by ZEngineer on February 09, 2006 at 01:46 PM
Message	I plan on building something to test for boost leaks the way the engine sees boost ( after the turbos) and taking it up to 20 psi or so... BEST 1/4mile 12.29 @ 112mph. "yo yo. writing this one in jail - tight300zx" I hope you got soap on a rope?? (n/m) - Spongerider :) 19:14:08 04/01/04 we'll know if the screen name changes ;) (n/m) - SactoTodd 19:32:36 04/01/04 "I did plug the holes, But I did it by taping over them a lot, I didnt think that maybe HOT air is comming through there, And it melted the tape, damnit im an ass." - - DC 21:11:01 02/18/04 (the "holes" were located on the exhaust)
Follow Ups	Boost gauge selection... boost/vac vs. just boost - Goose1451 12:25:10 02/09/06 vac shows leaks. - ni[X]it 12:28:07 02/09/06 What's the regular vaccum for a tt engine? (n/m) - zboost(tx) 13:14:15 02/09/06 my gauge sat at 19-20 *whatever the units are* - ZEngineer 13:25:26 02/09/06 sounds about right (n/m) - Guapo 13:31:27 02/09/06 inch of mercury. (n/m) - CHUNG (Dallas) 15:13:01 02/09/06 IIRC, my shows ~15" of mercury or whatever unit it is - chenc544 13:25:45 02/09/06 at 15", your engine wouldn't idle smooth. An engine that - CHUNG (Dallas) 15:05:16 02/09/06 Thanks for the info - chenc544 16:37:12 02/09/06 Just checked.... 20 inHG at idle.. im good :) (n/m) - zboost(tx) 13:39:27 02/09/06 do not use it as a means to verify for boost/vacuum leaks - ZEngineer 13:46:18 02/09/06 I know - zboost(tx) 13:51:44 02/09/06
Post a Followup	You cannot reply to this message because you are not logged in.