Subject	my gauge sat at 19-20 *whatever the units are*
Posted by	ZEngineer on February 09, 2006 at 1:25 PM
	This message has been viewed 26 times.
In Reply To	What's the regular vaccum for a tt engine? (n/m) posted by zboost(tx) on February 09, 2006 at 01:14 PM
Message	at some point, it would read 16 or 17 *whatever units*, it turns out that one of the rubber caps I was using on one of the nipples on the throttle body had popped off. I replaced the cap and was back at 19-20. I believe the units are millimeters of mercury. _________________________________________________________________________________ "The Z is the cause and the solution to all my problems" -- Me manstretch: well, my rear end is just worn out ZEngineer24: sig quote
Follow Ups	Boost gauge selection... boost/vac vs. just boost - Goose1451 12:25:10 02/09/06 vac shows leaks. - ni[X]it 12:28:07 02/09/06 What's the regular vaccum for a tt engine? (n/m) - zboost(tx) 13:14:15 02/09/06 my gauge sat at 19-20 *whatever the units are* - ZEngineer 13:25:26 02/09/06 sounds about right (n/m) - Guapo 13:31:27 02/09/06 inch of mercury. (n/m) - CHUNG (Dallas) 15:13:01 02/09/06 IIRC, my shows ~15" of mercury or whatever unit it is - chenc544 13:25:45 02/09/06 at 15", your engine wouldn't idle smooth. An engine that - CHUNG (Dallas) 15:05:16 02/09/06 Thanks for the info - chenc544 16:37:12 02/09/06 Just checked.... 20 inHG at idle.. im good :) (n/m) - zboost(tx) 13:39:27 02/09/06 do not use it as a means to verify for boost/vacuum leaks - ZEngineer 13:46:18 02/09/06 I know - zboost(tx) 13:51:44 02/09/06
Post a Followup	You cannot reply to this message because you are not logged in.