Subject	So a little tap with a small tool can break off that center
Posted by	jzack on February 05, 2006 at 6:44 PM
	This message has been viewed 26 times.
In Reply To	Need torx bit for steering wheel swap posted by ltullos on February 05, 2006 at 04:01 PM
Message	screw stud. Then the bit you have will work - I haven't done this myself, but from other postings it's suppose to be pretty easy to accomplish. I don't see the downside of doing this - worst case (doesn't break cleanly), it could be drilled or dremel ground out
Follow Ups	Need torx bit for steering wheel swap - ltullos 16:01:19 02/05/06 Re: Need torx bit for steering wheel swap - mphill 16:07:30 02/05/06 You need a torx "security bit" - mattztt 16:18:06 02/05/06 Got mine from advanced auto parts. (n/m) - 300zib(NoVA) 16:48:34 02/05/06 T50 Security Bit. (n/m) - YugoBernie (NoVA) 18:03:32 02/05/06 yuppers. (n/m) - Zluster(Sir Sam) 18:21:26 02/05/06 So a little tap with a small tool can break off that center - jzack 18:44:20 02/05/06 Use a vice grip to turn it, worked on my NX2k (n/m) - Crim 22:33:17 02/05/06
Post a Followup	You cannot reply to this message because you are not logged in.