Subject	why don't you have a professional machine shop do
Posted by	MikeH(Phoenix) on April 16, 2001 at 1:02 AM
	This message has been viewed 15 times.
In Reply To	Damnit Damnit! NA -> TT engine conversion woes! posted by AshsZ (In Florida) on April 15, 2001 at 07:05 PM
Message	the short block. That's what I did. They are the experts and have the proper measuring instruments. Also they can balance the bottom end to zero grams . Unless you want a vibration free balanced motor have a reputable machine shop do it. Mike Dynoed 400 RWHP @ 19 psi 384 RWHP @ 17psi On Stock Turbos. Dynoed 515 rwhp and 420 ft.lbs @ 16psi 89 degrees. 533 rwhp and 450 ft. lbs @19 psi and slipping clutch and heat soaked motor , 85 degrees.
Follow Ups	Damnit Damnit! NA -> TT engine conversion woes! - AshsZ (In Florida) 19:05:40 04/15/01 Re: Damnit Damnit! NA -> TT engine conversion woes! - ImTheDevil 19:47:29 04/15/01 Thanks! My car still has an engine tho.. Its driveable>> - AshsZ (In Florida) 06:20:02 04/16/01 piston gap - wickdGSXR 20:11:28 04/15/01 That is too much clearance for stock pistons. (n/m) - MikeH(Phoenix) 01:04:05 04/16/01 hey stick with it, and good luck (n/m) - cheezoto(OKC) 23:21:33 04/15/01 why don't you have a professional machine shop do - MikeH(Phoenix) 01:02:57 04/16/01 Thanks for the input, but I trust myself more than a shop>>> - AshsZ (In Florida) 06:34:38 04/16/01
Post a Followup	You cannot reply to this message because you are not logged in.