Subject	Step is really not needed me thinks
Posted by	Spddracer on February 01, 2006 at 9:35 PM
	This message has been viewed 44 times.
In Reply To	Deep thoughts, by Guapo ... posted by Guapo on February 01, 2006 at 09:16 PM
Message	It will throw the pressure plate off very slightly but will make the clutch stiffer if anything at all. Won't casue any problems if its not there. I "assume" the step was put there to make the TT clutch a little easier to push.
Follow Ups	Deep thoughts, by Guapo ... - Guapo 21:16:07 02/01/06 get B&B! (n/m) - Zster (Big Red) 21:16:51 02/01/06 placebo - LJZTT 21:27:48 02/01/06 get sways (n/m) - Guapo 21:29:06 02/01/06 Why. Stocks are better. (n/m) - CrazyGreek 00:08:39 02/02/06 had my Jun stepped (n/m) - bankruptedz 21:29:34 02/01/06 Step is really not needed me thinks - Spddracer 21:35:55 02/01/06 How/why does the step make the clutch easier to push? - Guapo 21:55:20 02/01/06 found an old thread that might help - WAGGZ 22:26:12 02/01/06 Maybe....just MAYBE, the aftermarket clutches are 0.008" - Dave N 22:07:33 02/01/06 The OEM FW is designed with enough material to resurface it - SniPer SR71 (Dallas) 22:14:07 02/01/06 whats that got to do with the step? (n/m) - Spee 22:20:41 02/01/06 After reading Seb’s post, my theory is inaccurate. - SniPer SR71 (Dallas) 22:52:26 02/01/06 I don't think that's the reason. If that was the case, all - Dave N 22:23:04 02/01/06 I hope you got them cut to .008", not .080"... (n/m) - Dallas DamonZ 22:38:30 02/01/06 yeah that :) (n/m) - Guapo 22:44:59 02/01/06 *smack* (n/m) - Dave N 22:50:26 02/01/06 I got it right at the machine shop :) (n/m) - Guapo 22:54:22 02/01/06 That's a relief. :-P - Dave N 22:56:20 02/01/06 Actually - as I recall the friction area on AM flywheels is - YugoBernie (NoVA) 23:05:33 02/01/06 Repost (n/m) - SeedyROM 00:20:06 02/02/06 RE: Deep thoughts, by Guapo - DVDBURN (MD) 08:47:20 02/02/06 is it .009"? (n/m) - Max865(ATL) 13:25:34 02/02/06
Post a Followup	You cannot reply to this message because you are not logged in.