Subject	I'm thinking that the drag racing folks would probably be
Posted by	Ash's Z on January 19, 2006 at 12:54 AM
	This message has been viewed 69 times.
In Reply To	impressive posted by maglito on January 19, 2006 at 12:25 AM
Message	pretty keen on getting something like this going. I didn't hesitate to free-rev my engine when I fired it off and this thing revs out like a crotch rocket. I'm sure it will be advantageous to bottom end grunt as well as top end power.. And like you said, you can pull a ton of heat out of the engine between runs while in the staging area. I'm meeting with my CNC shop next week to produce a second water pump assembly as well as machine a backplate that is fashioned like the face of the cylinder block. This plate will have two pipes on the back of it that I can connect it in a closed loop setup where I can bring it up to ~16psi of pressure as well as have a heated reservoir to allow me to simulate engine conditions. Then just turn it on and let it run till it starts puking fluid and go from there. I just dont plan to put a ton of miles on my car and trying to test it that way wouldn't give good results until a few years down the road. So, at this point it is still heavily under development but expect something around summertime. [ ashspecz.com ] [ agpowers@bellsouth.net ] Enthusiasts soon understand each other. --W. Irving. Are you an enthusiast? If you are out to describe the truth, leave elegance to the tailor. Albert Einstein
Follow Ups	AshsZ-II Ultimate Street Z Progress: Fan Shroud Pt1 - Ash's Z 00:12:46 01/19/06 WOW nice work! Cant wait to see the end result. - 300zib(NoVA) 00:16:52 01/19/06 Awesome man! Keep em' coming! (n/m) - Shawn300zTT GT28R MD 00:27:19 01/19/06 whoops, that was meant for Ash.. - Shawn300zTT GT28R MD 04:54:32 01/19/06 Re: so is this...Ash,you're not working in your PJ's again, - racer2fst 07:59:35 01/19/06 That's nice & all but can you make it in green felt? (n/m) - YugoBernie (NoVA) 00:19:33 01/19/06 Rad shrouds were made to be warm, but not fuzzy. :) (n/m) - Ash's Z 00:23:16 01/19/06 O and you lost me with al that dam mathematics - 300zib(NoVA) 00:20:05 01/19/06 Members/ Edit Profile/ Include original message in reply: NO (n/m) - 300zx90 (CO) 00:33:44 01/19/06 Genius. - Knapper411 00:20:23 01/19/06 very nice, (n/m) - blacktwin 00:21:54 01/19/06 What about the electric fan units with 2 9" fans in them? - Knapper411 00:25:21 01/19/06 mmmmmmm.......Pie. (n/m) - WAGGZ 01:17:02 01/19/06 impressive - maglito 00:25:33 01/19/06 lol (n/m) - Guapo 00:29:25 01/19/06 You'd rather burn $6+ per gallon fuel between sessions - maglito 01:18:52 01/19/06 ... oh, you were serious? (n/m) - Guapo 09:10:40 01/19/06 yes - maglito 09:30:54 01/19/06 couple things ... - Guapo 09:39:20 01/19/06 I have reserved a spot in a private track day on Feb 12th - Ash's Z 09:50:50 01/19/06 Cool. Just don't forget to let the car run for a couple - Guapo 09:54:24 01/19/06 LOL, I'm not greenie to it. I have a stash of trophies now - Ash's Z 10:07:43 01/19/06 wow .. I wasn't aware you had roadcoursed before. - Guapo 10:15:35 01/19/06 Yeah, back in Gainesville it was the #1 thing I was involved - Ash's Z 10:28:20 01/19/06 ok now we have to know...17" or 18" track wheels? - maglito 10:37:12 01/19/06 Just because the association you were affiliated with - Guapo 10:53:36 01/19/06 Yo El Guapo. Did you ever do a write about about your - Scotts94z32 11:05:45 01/19/06 you have email, sir (n/m) - Guapo 11:59:20 01/19/06 muchas gracias (n/m) - Scotts94z32 12:28:22 01/19/06 SCCA solo and solo2 events, yes, I have participated - Ash's Z 11:10:55 01/19/06 ah so autocross, not roadcourse. what fun :) (n/m) - Guapo 11:18:15 01/19/06 Well that's really apples and oranges. - Kenny 11:27:05 01/19/06 I'm actually always in 2nd. (n/m) - Scotts94z32 12:22:20 01/19/06 wow - maglito 10:17:26 01/19/06 I would hope he would throughly test it - maglito 09:52:51 01/19/06 yeah, there are devices that will circulate your oil for you - Technomancer 10:57:09 01/19/06 If this is really a concern... - Kenny 11:04:08 01/19/06 this is actually what I do, and what I recommend - Technomancer 12:53:53 01/19/06 Can you scan in the plot? - Kenny 13:06:06 01/19/06 It's buried with the rest of my physics office stuff - Technomancer 14:19:02 01/19/06 Oil is the key, you are correct - Rule12b 12:33:52 01/19/06 Then your fan clutch or cooling system has problems. (n/m) - YugoBernie (NoVA) 00:40:45 01/19/06 fan clutch is old and could used to be replaced - maglito 01:15:44 01/19/06 That logic only holds if the electric unit out performs the - YugoBernie (NoVA) 07:59:36 01/19/06 Yes it has been shown time and time again electric fans - maglito 09:24:24 01/19/06 wait wait wati - Spee 10:11:52 01/19/06 they are easy to change anytime - maglito 10:19:41 01/19/06 but you still were going to put it back. - Spee 10:37:26 01/19/06 If I noticed my coolant temp rising in stop and go traffic - maglito 10:53:45 01/19/06 2nd. The stock system is more than adequate. (n/m) - ENVYMYZ 09:19:54 01/19/06 I'm thinking that the drag racing folks would probably be - Ash's Z 00:54:58 01/19/06 I am sure the free reving had somthign to - Shawn300zTT GT28R MD 04:57:56 01/19/06 Knife'd crank...lucky! :) (n/m) - BradZ (FL) 09:28:55 01/19/06 Um, count me in for this setup, genius. . . (n/m) - Rule12b 01:01:16 01/19/06 If it works out of course ;-) (n/m) - Rule12b 12:29:58 01/19/06 cuz god is never wronge. (n/m) - Halo Z 05:27:42 01/19/06 ??? the cool down lap is plenty (n/m) - kuah@splparts.com 09:38:25 01/19/06 I used to have to let my car cool for sometime - maglito 10:07:05 01/19/06 *agreed* even on the shortest course I can take at least - Scotts94z32 11:12:30 01/19/06 Ash, use that mold to make an ABS plastic shroud - jkeyser14 01:12:36 01/19/06 Interesting you suggest that. I went by a fiberglass shop - Ash's Z 01:42:48 01/19/06 crap, I was burning through the pics without reading - robo (sebring1970) 01:21:07 01/19/06 ROFL.. T4 Powered Radiator!! (n/m) - CrazyGreek 01:30:41 01/19/06 ha! usurped once again! thanks, Ash ;c) (n/m) - robo (sebring1970) 01:50:37 01/19/06 It also has nitrous. That pretty blue bottle is the sh@t! - Ash's Z 01:52:45 01/19/06 Cool. Looks like you have fun every day. (n/m) - WAGGZ 01:21:24 01/19/06 You are simlpy nuts! - Jared Todd 01:57:01 01/19/06 you are the man! (n/m) - mge_1 03:42:33 01/19/06 master!!!!!!!!!!!!! (n/m) - E=mz² 07:11:21 01/19/06 Is there anything you can't fab? - Madhatter10-6 07:39:34 01/19/06 great fab job! - bobZtwin (NC) 07:46:10 01/19/06 MEK is illegal to purchase or posses. - ni[X]it 07:52:22 01/19/06 I'm just curious; - ni[X]it 07:47:26 01/19/06 i dont think we are talking about this latest - E=mz² 07:54:23 01/19/06 So is this a shallow attempt at validation on Ashs part? - ni[X]it 07:59:53 01/19/06 yea dude, lets see what you got! competition is what - E=mz² 08:18:37 01/19/06 http://ashspecz.com/index.htm - E=mz² 08:25:27 01/19/06 Whore (n/m) - BigTDogg (MA) 09:12:20 01/19/06 I bet plenty here would like to see them :) - The Sixth 08:33:57 01/19/06 Post some pics of your creations.... - dpjax 08:42:52 01/19/06 So let's see a few examples... - 90Z-NA (ATL) 08:43:22 01/19/06 You have no idea... (n/m) - maglito 09:33:09 01/19/06 Are you referring to ni[x]it's vast store of ideas? - 90Z-NA (ATL) 10:01:37 01/19/06 he doen't like it when I talk about all the stuff he makes - maglito 10:10:24 01/19/06 Re: he doen't like it when I talk about all the stuff he makes - ni[X]it 10:20:22 01/19/06 You're right... - 90Z-NA (ATL) 10:23:16 01/19/06 Re: You're right... - zsoom 17:41:41 01/19/06 lol (n/m) - Spee 10:32:20 01/19/06 Man, are your hands in casts? - 90Z-NA (ATL) 11:44:16 01/19/06 He's laughing at the stupid part. - Kenny 11:58:50 01/19/06 Ugh... - 90Z-NA (ATL) 13:00:01 01/19/06 I see humor recognition isn't one of yours. (n/m) - Kenny 13:04:53 01/19/06 :-) Certainly not in the context of this debate. - 90Z-NA (ATL) 13:11:33 01/19/06 no - Spee 12:03:34 01/19/06 Which again illustrates my point... - 90Z-NA (ATL) 12:36:50 01/19/06 the difference is when he isn't usually showing off one offs - maglito 09:19:18 01/19/06 I dont think you understand my position on the matter. - Ash's Z 09:45:59 01/19/06 Thank you for your long reply. Very good. - ni[X]it 10:16:08 01/19/06 You seem to miss your own point here... - 90Z-NA (ATL) 10:28:27 01/19/06 How can he miss his own point? (n/m) - Kenny 13:11:15 01/19/06 By failing to see how it applies to others... (n/m) - 90Z-NA (ATL) 13:21:45 01/19/06 "followers" (n/m) - Spee 10:30:23 01/19/06 Looks good... - turtleboy 07:48:15 01/19/06 Circle wont fit properly into a square port ? - Dark Diver 08:48:55 01/19/06 couldn't have dont it better myself. great work! =) (n/m) - Ted(Snowflake Customs) 09:13:32 01/19/06 Is your radiator divided on the right tank? - Spddracer 10:49:45 01/19/06 Re: Is your radiator divided on the right tank? - Kenny 10:53:57 01/19/06 Looks very similar to what my roommate made for his. - Woody75 (Denver) 13:12:20 01/19/06 it's that high altitude causing it to overheat - the chapstick bandit 13:16:30 01/19/06 Can't be that. - Woody75 (Denver) 14:16:08 01/19/06 Please. I have never said or believed anything of the sort. - Ash's Z 15:29:27 01/19/06 One thing to note though, - Woody75 (Denver) 13:22:10 01/19/06 Nice..you have e-mail.. (n/m) - myzislow 13:13:57 01/19/06
Post a Followup	You cannot reply to this message because you are not logged in.