Subject	Thread Pitch and Size of Oil Pedelstal Bolt
Posted by	Atl300zxTT (Productive) on January 12, 2006 at 9:02 AM
	This message has been viewed 179 times.
Message	I want to get a replacement bolt for oil pedelstal so my JWT 530BB clear it. The picture below shows the bolt that i need. i would prefer not to grind it down so that i dont compromise the integrity of the head. I would rather get a lower profile bolt, perhaps once with a hex key head (kinda like the second pic). Does anyone know the Thread Pitch and Size of Oil Pedelstal Bolt??? Also anyone had any luck finding a low profile one? Thanks.
Follow Ups	Thread Pitch and Size of Oil Pedelstal Bolt - Atl300zxTT (Productive) 09:02:12 01/12/06 take the bolt out and measrue it... - pilotgod404 09:08:36 01/12/06 i would take it out, but i wanted to go to McMaster Carr - Atl300zxTT (Productive) 09:17:34 01/12/06 Should be 8x1.25 or 10x1.25 , 12mm head is a 8mm bolt - Spddracer 09:15:06 01/12/06 something like this... - Atl300zxTT (Productive) 09:43:26 01/12/06 Just checked. - EricTTZ 09:59:45 01/12/06 awesome thanks...is there an untreaded portion? - Atl300zxTT (Productive) 10:01:25 01/12/06 fully threaded (n/m) - EricTTZ 10:13:11 01/12/06 thanks, you just saved me 45 minutes of driving (n/m) - Atl300zxTT (Productive) 10:15:30 01/12/06 I notched the oil filter housing and used a shorter bolt (n/m) - Joe(NoVA) 10:22:10 01/12/06 seems like a lot more work...good back up plan if i cant - Atl300zxTT (Productive) 10:34:26 01/12/06
Post a Followup	You cannot reply to this message because you are not logged in.