Subject	By what I got out of a conversation with a machinast...
Posted by	WAGGZ on January 11, 2006 at 12:34 AM
	This message has been viewed 70 times.
In Reply To	Heads: Extrution honing VS Port and polishing posted by ryanb300zx on January 11, 2006 at 12:25 AM
Message	Extrude hone is done by blasting media/sand at high velocities that flow at true flow paths. Porting is done by hand and may not have the right contures of flow as does extrude because thats how extrude works...actual flow. I hope I'm right becaus I was drunk when I thought I had the conversation. :)
Follow Ups	Heads: Extrution honing VS Port and polishing - ryanb300zx 00:25:43 01/11/06 By what I got out of a conversation with a machinast... - WAGGZ 00:34:01 01/11/06 thats kinda where im at. : ) - ryanb300zx 00:41:35 01/11/06 not at high velocity. low velocity, high pressure. (n/m) - SactoTodd 01:02:43 01/11/06 I believe it is a "clay" that is forced though by doing - Shawn300zTT GT28R MD 01:15:15 01/11/06 Oh. I was thinking it as more of a sand blast method. Thanx (n/m) - WAGGZ 07:41:57 01/11/06 To my understanding ... - NytWolf 01:08:39 01/11/06 I certify this as a Kenny Approved (TM) reply. (n/m) - Kenny 01:10:38 01/11/06 got ego issues? (n/m) - ZEngineer 08:29:04 01/11/06 lol, got inferiority complex? (n/m) - Kenny 09:02:58 01/11/06 I doubt my answer to that would be Kenny Approved(TM) (n/m) - ZEngineer 09:19:50 01/11/06 It's a lofty standard. (n/m) - Kenny 10:07:04 01/11/06 great standards...that sometimes take a day off - ZEngineer 10:26:52 01/11/06 It's not my fault you have no sense of humor. (n/m) - Kenny 10:45:09 01/11/06 Since your response is Kenny approved, and... - ryanb300zx 01:18:18 01/11/06 Err... cam choice? What turbos are you going to use? (n/m) - Kenny 01:23:56 01/11/06 Im asking these questions for a friend... - ryanb300zx 01:29:55 01/11/06 The JWT mild cam doesn't do much if I recall. - Kenny 01:42:49 01/11/06
Post a Followup	You cannot reply to this message because you are not logged in.