TwinTurbo.NET: Nissan 300ZX forum - Block milling problem
People Seeking Info
 
   


     
Subject Block milling problem
     
Posted by Loquatios7 on January 03, 2006 at 8:05 AM
  This message has been viewed 26 times.
     
In Reply To Re: Stay away from early 90 300ZX models? posted by T(Seattle) on January 02, 2006 at 08:48 PM
     
Message I read somewhere that there was a problem with the CAS on the early 90's blocks because one side was milled improperly.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.