Subject	Ah good to know, thanks (n/m)
Posted by	CaliguyPurdue on December 29, 2005 at 12:49 PM
	This message has been viewed 27 times.
In Reply To	only if the tranny is tilted down far enough (n/m) posted by Moxie on December 29, 2005 at 12:40 PM
Message
Follow Ups	Anybody install the Nyx driveshaft? - nismo805 11:02:50 12/29/05 Yep. Take out old put in new. (n/m) - cop-z 11:04:01 12/29/05 pretty much (n/m) - Moxie 11:13:35 12/29/05 Very easy just take our time and do it right. - 300zib(Dam ticking sound) 12:07:25 12/29/05 Its really easy, remove the Exhaust, discounect the OEM shaf - Eishozzzz 12:10:41 12/29/05 Make sure you mark the splines so you line the new one... - CaliguyPurdue 12:38:40 12/29/05 only if the tranny is tilted down far enough (n/m) - Moxie 12:40:54 12/29/05 Ah good to know, thanks (n/m) - CaliguyPurdue 12:49:42 12/29/05 will i need a torque wrench - nismo805 13:30:53 12/29/05 a 3/8 allen key... or drive socket if i rember correctly (n/m) - joker_20_02 (Rebuilding) 14:39:40 12/29/05
Post a Followup	You cannot reply to this message because you are not logged in.