Subject	only if the tranny is tilted down far enough (n/m)
Posted by	Moxie on December 29, 2005 at 12:40 PM
	This message has been viewed 27 times.
In Reply To	Make sure you mark the splines so you line the new one... posted by CaliguyPurdue on December 29, 2005 at 12:38 PM
Message
Follow Ups	Anybody install the Nyx driveshaft? - nismo805 11:02:50 12/29/05 Yep. Take out old put in new. (n/m) - cop-z 11:04:01 12/29/05 pretty much (n/m) - Moxie 11:13:35 12/29/05 Very easy just take our time and do it right. - 300zib(Dam ticking sound) 12:07:25 12/29/05 Its really easy, remove the Exhaust, discounect the OEM shaf - Eishozzzz 12:10:41 12/29/05 Make sure you mark the splines so you line the new one... - CaliguyPurdue 12:38:40 12/29/05 only if the tranny is tilted down far enough (n/m) - Moxie 12:40:54 12/29/05 Ah good to know, thanks (n/m) - CaliguyPurdue 12:49:42 12/29/05 will i need a torque wrench - nismo805 13:30:53 12/29/05 a 3/8 allen key... or drive socket if i rember correctly (n/m) - joker_20_02 (Rebuilding) 14:39:40 12/29/05
Post a Followup	You cannot reply to this message because you are not logged in.