Subject	I ran the 4ga through an existing grommet on the >>
Posted by	Mike (Austin) on April 11, 2001 at 3:09 PM
	This message has been viewed 18 times.
In Reply To	Ideas on how to mount 4awg to battery? Where to run wire? posted by Mike@ZSpeed on April 11, 2001 at 08:37 AM
Message	driver's side. Only thing that sucks is that you then have to go across the engine bay along the firewall to get to the battery. That area tends to get pretty 'busy' when you start adding aftermarket parts. A lot of my AVC-R and old-school HKS BOV wiring and vacuum lines run along there as well. Good luck! Mike
Follow Ups	Ideas on how to mount 4awg to battery? Where to run wire? - Mike@ZSpeed 08:37:08 04/11/01 wtf!? what are you running in your Z? washer/dryer? - nixit(stalker) 08:39:57 04/11/01 Re: wtf!? what are you running in your Z? washer/dryer? - Mike@ZSpeed 08:49:00 04/11/01 ok check it out>>>> - Like Zo 09:00:13 04/11/01 I think i seen them in cruchfield. (n/m) - Like Zo 09:02:06 04/11/01 man, that's SERIOUS overkill. - nixit(stalker) 09:07:23 04/11/01 If you compete "by the rules" 4ga. is required!! - Spectrum (WI) 11:43:16 04/11/01 A couple things/thoughts >> - MikeeZ 12:04:24 04/11/01 On a side note, got any pics of your car? :) - SeedyRom (Fix my PING!) 12:25:37 04/11/01 Any alternative ways to run wire? - Mike@ZSpeed 15:17:47 04/11/01 I ran the 4ga through an existing grommet on the >> - Mike (Austin) 15:09:02 04/11/01
Post a Followup	You cannot reply to this message because you are not logged in.