TwinTurbo.NET: Nissan 300ZX forum - I had my machine shop do it($10). So I am not sure but
People Seeking Info
 
   


     
Subject I had my machine shop do it($10). So I am not sure but
     
Posted by Agner.S on December 21, 2005 at 11:48 PM
  This message has been viewed 18 times.
     
In Reply To what is the best tool or bit for removing it? (n/m) posted by AzHeat on December 21, 2005 at 10:35 PM
     
Message if you buy the dremel grinding kit it should be enough.

If you decide to have a machine shop do it make sure you check it out. Mine accidentally forgot the first time.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.