| I dont know how much use this will be but I figured I was making one I might as well post how. Oh and this ones for Bernie:) This is a new style coolant sensor connector I have been working on. You can use the coolant sensor from a 96ish maxima for the sensor to go along with this connector. Gives you a much better seal against corrosion. If you have the green fuzz coming out of your with the broken rubber hat boot this is for you. No more poor sealing ugly coolant sensor connections! This gives you a double rubber seal on the connection so it should outlast your car. Basically these are the steps involved. 
...............................................Install Silicone seal.
................The orange piece locks the connectors in so they cannot pull out and also applies tension to the pins.
src="http://www.photodump.org/stored2/000_2897.JPG">
..................................One connector made for Bernie!
If you prefer the old style sensor I have you fixed up also.
This is a newer style yet same plug for the old sensor. This rids the lil black boot that breaks and lets moister in the the connection. It seals inside the connector instead of relying on a brittle rubber boot. 
...............................Need any connectors???????????? I have a few extras!
|
Connector Assembly 101 - 
