Subject	Re: chip of passenger head
Posted by	canyoncarver on December 20, 2005 at 1:56 PM
	This message has been viewed 24 times.
In Reply To	chip of passenger head posted by SkiFly01 on December 19, 2005 at 11:55 PM
Message	Welding is best. You should make sure whoever does it knows about welding cast aluminum. Pretty sure you need a specific filler material. Wouldn't want it to pop out after a few heat cycles. An added bit of insurance might be to have the welded area penetrant inspected afterwards. ____________________________ '93 n/a slicktop stage 0 My CarDomain
Follow Ups	chip of passenger head - SkiFly01 23:55:23 12/19/05 Re: chip of passenger head - tdogzjoint 00:06:51 12/20/05 Re: chip of passenger head - wilkendw 00:07:04 12/20/05 well that blows goats... - SkiFly01 00:18:42 12/20/05 do you still have the heads from your old motor? (n/m) - emo236 00:28:07 12/20/05 yea I can use them but didnt want to, was going to - SkiFly01 00:29:12 12/20/05 that sounds painful, I hope he's alright ;c) (n/m) - robo (sebring1970) 01:50:58 12/20/05 welding is pos. Alumina flux works well, it melts with - FL_ZX(NA_stage3) 01:54:32 12/20/05 wouldnt it be possible for the weld with that stuff to - tyreeztt 09:59:00 12/20/05 that can be easily welded - aliaZ 07:38:03 12/20/05 Thats not bad at all, (from what I can see) - Shawn300zTT GT28R MD 07:46:51 12/20/05 how is your foot? (n/m) - AzHeat 10:43:09 12/20/05 Re: chip of passenger head - canyoncarver 13:56:05 12/20/05
Post a Followup	You cannot reply to this message because you are not logged in.