Subject	man, that's SERIOUS overkill.
Posted by	nixit(stalker) on April 11, 2001 at 9:07 AM
	This message has been viewed 20 times.
In Reply To	Re: wtf!? what are you running in your Z? washer/dryer? posted by Mike@ZSpeed on April 11, 2001 at 08:49 AM
Message	: MB Quart 218.03cx 6.5" components : MB Quart RKC 116 6.5" coaxils : US Acoustics 4085 amp : US Acoustics 2150 amp : 1.5 farad digital cap : 715 watts RMS :) nice setup, but you're still significantly over kill on the wire gauge, even with the Cap. I'd still recommend 10 gauge, but 8 give a little safety margin. : hahah with all the $ invested I'm not gonna be cheap on my wire. don't go cheap on wire, but use the appropriate size. for what you've got, 8-10 gauge is perfect. : Gonna run the 4awg to a distro. block then split into 2 awg outs. you know your amps use 10 gauge power inputs (10 is smaller than 2). "No one single car is the ultimate biggest baddest ass of them all (except for the A-Team van)"
Follow Ups	Ideas on how to mount 4awg to battery? Where to run wire? - Mike@ZSpeed 08:37:08 04/11/01 wtf!? what are you running in your Z? washer/dryer? - nixit(stalker) 08:39:57 04/11/01 Re: wtf!? what are you running in your Z? washer/dryer? - Mike@ZSpeed 08:49:00 04/11/01 ok check it out>>>> - Like Zo 09:00:13 04/11/01 I think i seen them in cruchfield. (n/m) - Like Zo 09:02:06 04/11/01 man, that's SERIOUS overkill. - nixit(stalker) 09:07:23 04/11/01 If you compete "by the rules" 4ga. is required!! - Spectrum (WI) 11:43:16 04/11/01 A couple things/thoughts >> - MikeeZ 12:04:24 04/11/01 On a side note, got any pics of your car? :) - SeedyRom (Fix my PING!) 12:25:37 04/11/01 Any alternative ways to run wire? - Mike@ZSpeed 15:17:47 04/11/01 I ran the 4ga through an existing grommet on the >> - Mike (Austin) 15:09:02 04/11/01
Post a Followup	You cannot reply to this message because you are not logged in.