TwinTurbo.NET: Nissan 300ZX forum - Yes, You will have to push the GT-R ones out from the back
People Seeking Info
 
   


     
Subject Yes, You will have to push the GT-R ones out from the back
     
Posted by EVON8 on December 11, 2005 at 10:34 PM
  This message has been viewed 34 times.
     
In Reply To No kidding... I loved your Z. posted by Payce on December 11, 2005 at 10:31 PM
     
Message Then use something to clean all of the sticky stuff off. Once thats done just stick the Z emblems on. I used some all purpose silicone to seal around the edges. I didn't want water getting in there and corroding them.

-Nate

Don't spend life spinning your tires, Buy AWD and save the rubber!

List of Mods:
HKS Racing Suction Intake
Blitz SBC-id (Set to 26-27psi)
Helix Catless midpipe/ down pipe
Turbo XS Catback
RMR Upper and Lower intercooler piping
HKS 264 intake & exhaust cams
Walbro 255lph Fuel Pump
Snow Performance Methanol Injection kit
Custom re-tuned by Mark of Turbo Trix (19Nov05) for 93 octane fuel and 100% Methanol Injection @ 26-27psi of boost

1/8th mile 60ft/ET/MPH: (Prior to Meth kit and Re-tune)
1.8181/ 8.0179@86.53 = 12.33 1/4 mile time

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.