Subject	where to get my block rebuilt?
Posted by	ChrisMedaris on December 05, 2005 at 12:49 PM
	This message has been viewed 68 times.
Message	i've pulled my motor, torn it down and now i need to send it off to have it brought back to mainly factory specs. with a few changed. clean out water passages, mainly number 6 cylinder 3 angle valve job maybe port and polish the heads i live in sherman, tx 50 miles north of dallas. i was thinkin about sending it to percision machinery in austin, anyone got a recommendation for me. thanks
Follow Ups	where to get my block rebuilt? - ChrisMedaris 12:49:30 12/05/05 SGP comes to mind... (n/m) - Scotts94z32 13:01:42 12/05/05 $2300 minimum (n/m) - ChrisMedaris 13:05:46 12/05/05 and WELL worth it. (n/m) - Zfreak(Dallas) 23:16:30 12/05/05 *Cough*..Import Parts Pro...*Cough*.....:-).... (n/m) - Kyle(Houston) 13:44:08 12/05/05 Are you okay? Do you need some water? - ssm300z 13:52:53 12/05/05 Can IPP do full rebuilds like SGP was/is doing? Thx. (n/m) - Scotts94z32 13:58:38 12/05/05 yes! (n/m) - Atl300zxTT (Less Lazy) 14:03:31 12/05/05 Kyle is THE man. :) go w/ him. VERY happy I did. (n/m) - spotz 17:45:56 12/05/05 Going by reputation... - A R T I E M E A S E 14:32:41 12/05/05 Close. Specialty Z or Import Parts Pro - BigTDogg (MA) 15:10:23 12/05/05 so SGPs reputation was built only on Kyle? (n/m) - dpjax 17:23:38 12/05/05 Besides the suggestions above you can also try - Luis (San Antonio) 15:41:25 12/05/05 Re: Besides the suggestions above you can also try (n/m) - I-xclr8 17:45:38 12/05/05 Re: Re: Besides the suggestions above you can also try - I-xclr8 18:00:59 12/05/05 actually... - ChrisMedaris 21:30:59 12/05/05 Re: actually... - I-xclr8 22:37:00 12/05/05
Post a Followup	You cannot reply to this message because you are not logged in.