Subject	I did Infinity Reference inside the air vents
Posted by	Elguapo (Dallas) on April 09, 2001 at 6:13 PM
	This message has been viewed 27 times.
In Reply To	audio component speaker question... posted by robbyg on April 09, 2001 at 02:22 PM
Message	I didn't have the balls o cut into the door panel. Plus, the imaging is very good from there. Stealthy, too. I just used the surface angle mount option that came with the set, and mounted it inside the vent. Happy, happy.
Follow Ups	audio component speaker question... - robbyg 14:22:22 04/09/01 They are usually held in by force. Make the hole a little - Gage (91TT Back in Business) 14:29:00 04/09/01 I went for angle mount on the trim piece at the top of>> - Mike ZZZ (Toronto) 14:32:18 04/09/01 get a surface mount tweeter (n/m) - dogpile 15:11:02 04/09/01 I've always wanted to try tweeters in a pillar gage pod. - Sweep 15:19:56 04/09/01 Go, for the A Pillar, better focus. Also, I reccomend... - NA300ZX (Tampa) 16:35:27 04/09/01 I did Infinity Reference inside the air vents - Elguapo (Dallas) 18:13:51 04/09/01
Post a Followup	You cannot reply to this message because you are not logged in.