Subject	hard wire (solder) and then move the connector
Posted by	TARGETZ on November 27, 2005 at 11:30 AM
	This message has been viewed 36 times.
In Reply To	That would be great and all, but how would you propose posted by whitepearlz on November 27, 2005 at 10:03 AM
Message	about couple/few inches away from the sensor Click on my Z to Email me! all of your oil are belong to U.S. I don't need data, it's all by observation, and weight :) (n/m) - Coz@CZP 11:26:02 07/31/05 AIM ID: TARGETZZ32
Follow Ups	Possible steps to make your harness BULIT PROOF! - Turnerscasa (Dallas) 09:51:29 11/27/05 Interesting! I have also been thinking about replacing - MidLifeZ 09:58:42 11/27/05 They make all sorts of sleeving, you can make it to resist - Turnerscasa (Dallas) 10:09:57 11/27/05 That would be great and all, but how would you propose - whitepearlz 10:03:35 11/27/05 I think you're right - aliaZ 10:09:21 11/27/05 I have been think a vented hood would make a huge - Ricerdaddy 10:18:54 11/27/05 I have an escort hood and DD main everywhere.>> - zboost(tx) 12:14:22 11/27/05 hard wire (solder) and then move the connector - TARGETZ 11:30:42 11/27/05 good luck - aliaZ 10:07:16 11/27/05 Considered your point. Most of what I will call proprietary - Turnerscasa (Dallas) 10:19:10 11/27/05 I've done it, but but with compatible connectors - z32ttvert (MWS Motorsports) 12:19:10 11/27/05 Good Post, However Nissan has been racing. - Turnerscasa (Dallas) 13:23:28 11/27/05 I don't think you understood what Michael (MWS) is saying - JokerF15 (NyxMotorsports) 14:08:53 11/27/05 Same connectors I used at my last job making - Shawn300zTT GT28R MD 15:47:18 11/27/05 I guess I need to add. This is a current connector - Turnerscasa (Dallas) 16:48:09 11/27/05 The ones I was using were Military grade, very top notch. (n/m) - Shawn300zTT GT28R MD 18:21:44 11/27/05 Whenever I have the chance - Spddracer 16:41:28 11/27/05 You should post a cross reference chart. - Turnerscasa (Dallas) 17:03:38 11/27/05 Try the macro setting (n/m) - EricTTZ 20:57:51 11/27/05 Try the macro setting (n/m) - EricTTZ 20:58:14 11/27/05 you had to splice in the new plugs correct? (n/m) - Max865(ATL) 22:51:32 11/27/05 Re: you had to splice in the new plugs correct? - Spddracer 06:30:45 11/28/05 i play with them all day long at work. had a bag full - Halo Z 20:13:18 11/27/05
Post a Followup	You cannot reply to this message because you are not logged in.