Subject	no thanks, but I will take some cast manifolds. (n/m)
Posted by	myzislow on November 27, 2005 at 10:38 AM
	This message has been viewed 28 times.
In Reply To	may I suggest cast aluminum? posted by aliaZ on November 26, 2005 at 10:32 PM
Message
Follow Ups	AshsZ-II Ultimate Street Z Progress: Turbo Inlet Pipes >>> - Ash's Z 20:48:10 11/26/05 Sweet! (n/m) - 91Z32TT 20:52:56 11/26/05 better everytime, cant wait for the finish product (n/m) - robert300zx 20:56:30 11/26/05 Looks great (n/m) - Cull1990Red300zx 21:00:54 11/26/05 Looks good (n/m) - F8IZHIS 21:01:17 11/26/05 Very nice (n/m) - zboost(tx) 21:03:54 11/26/05 Nice, cant wait to see it done! (n/m) - Madhatter10-6 21:17:09 11/26/05 Nice! (n/m) - TheTwinZ (Peru) 21:27:42 11/26/05 lookin good - luke21 22:14:14 11/26/05 may I suggest cast aluminum? - aliaZ 22:32:27 11/26/05 Looks like a lot more trouble than it is worth to cast - Ash's Z 22:40:02 11/26/05 those cast ones don't look bad. Might concider - Ricerdaddy 22:54:31 11/26/05 no thanks, but I will take some cast manifolds. (n/m) - myzislow 10:38:27 11/27/05 Those won't possibly be available for the 'pre-clocked" - Shawn300zTT GT28R MD 15:55:16 11/27/05 I don't know, but I'll ask (n/m) - aliaZ 20:08:35 11/27/05 Also, These aren't required for the use of the MS mani's - Shawn300zTT GT28R MD 15:56:50 11/27/05 no, not required - aliaZ 20:07:30 11/27/05 my turbo inlet pipes are straighter then urs heheh (n/m) - suprakillinz(boulder soon) 23:34:52 11/26/05
Post a Followup	You cannot reply to this message because you are not logged in.