Subject	for all those looking for 60mm throttle bodies
Posted by	reebok182 on November 18, 2005 at 12:12 AM
	This message has been viewed 376 times.
Message	just a quick drawing i did everything aside from the opening is like stock so it will easily bolt up to the upper plenum. it would keep the same shaft assembly and need a new butterfly of course but hey its just a quick thing that i'm going to research further. this assembly doesnt show measurement on the paper. sorry. also too it would take into account that you removed most of ur emission controls and the water bypass. thoughts anyone?
Follow Ups	for all those looking for 60mm throttle bodies - reebok182 00:12:23 11/18/05 pretty cool if you can get it produced (n/m) - Z32POWER.com 05:38:54 11/18/05 where is the rest of it? - nixit 08:00:13 11/18/05 "just a quick drawing" seemed to sum it up (n/m) - dpjax 09:17:54 11/18/05 lol yup pretty much. (n/m) - ENVYMYZ 10:00:02 11/18/05 yea quick drawing - reebok182 10:18:07 11/18/05 You have email (n/m) - bankruptedz 12:39:33 11/18/05 you have a prototype yet? It looks like a solid machined - WAGGZ 13:00:56 11/18/05
Post a Followup	You cannot reply to this message because you are not logged in.