Subject	Mike Smith will make a stroker kit with minimal bore
Posted by	SirpriZ on November 17, 2005 at 1:47 AM
	This message has been viewed 171 times.
In Reply To	300zx Stroker kits? posted by donthaveone on November 16, 2005 at 09:15 PM
Message	increase (there are dangers to overboring our blocks), that he says will cost about half of what a Jun kit will cost and will be about 3.3 liters (a 10% increase in cid). Contact him thru JWT at 619 442-0680. Take care, Mark
Follow Ups	300zx Stroker kits? - donthaveone 21:15:18 11/16/05 Re: 300zx Stroker kits? - upcominZ_NA>TT 21:18:12 11/16/05 Re: Re: 300zx Stroker kits? - donthaveone 21:20:37 11/16/05 FWIR, they have a 3.2 kit available at a few vendors (n/m) - Waco300zx 21:27:07 11/16/05 way to expensive - reebok182 21:24:30 11/16/05 I'm going to email Jun and see if they want to give me one.. - ryanb300zx 21:50:27 11/16/05 You could... - WAGGZ 22:11:02 11/16/05 These guys all have outdated info - ZisLuv 22:19:32 11/16/05 might wanna check the math on that one - reebok182 22:39:57 11/16/05 Guess you didnt read my post at all? (n/m) - ZisLuv 22:48:22 11/16/05 The 90mm part or the increased stroke part? (n/m) - 300zx90 (CO) 09:44:40 11/17/05 Re: 300zx Stroker kits? - icsamerica 22:27:53 11/16/05 Light weight rods - ZisLuv 22:51:48 11/16/05 Mike Smith will make a stroker kit with minimal bore - SirpriZ 01:47:50 11/17/05 You again! - CrazyGreek 02:23:42 11/17/05 increased stroke = increased piston speed = lower rev limit - Z32POWER.com 05:26:12 11/17/05 Hmm I will have to look and see what they changed to make - Spddracer 08:31:01 11/17/05 email mike kojima... - AntiHero 08:44:16 11/17/05
Post a Followup	You cannot reply to this message because you are not logged in.