TwinTurbo.NET: Nissan 300ZX forum - Mike Smith modifies the inlet and outet (increasing)
People Seeking Info
 
   


     
Subject Mike Smith modifies the inlet and outet (increasing)
     
Posted by SirpriZ on November 11, 2005 at 5:12 PM
  This message has been viewed 112 times.
     
In Reply To the major downside of the stillens is the inlet and outlets posted by maglito on November 11, 2005 at 01:49 PM
     
Message the ID but keeping the OD the same. I'm not sure of the increased performance numbers, but if you send him your aftermarket ICs (especially Stillen), he'll send them back to you with a larger ID, where a big cork in the system is....I don't know the difference in the before and after dimensions, but he claims the performance gains are significant. Call him at JWT and find out more info. I don't know how much Ash's performance gains are from his increased dimensions on the face and surface area, and how much is due to the increase in the inlet and outlet dimensions. But good work, none-the-less. Take care, Mark
     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.