| yes its true - ran out of gas on the dyno. Short story. Long story - Ash is going back to the dyno tomorrow to finish 4 baseline pulls and then re-tune / make some pulls with the water injection on. Today - we ran baseline pulls up to 1.5bar ~ 22psi. I would post all the dynos - but I don't want to misrepresent the data because I only have the runfiles numbers and I am going off of memory on what the psi / bar levels are. Ash has that data. But I do recall a few of the pulls and I will show the detail of those pulls as compared to Saturdays pulls. I can tell you that the install and quality of the massive Ash-spec intercoolers and 2.5 inch piping is real nice. Fittment is pretty spot on with few modifications. I'm sure Ash will have a nice long lengthy write up showing the pictures that he took today. We spent 3 hours on the dyno today. Started blowing off blowoff valves , vacuum lines, and hard pipes. So we left the dyno for more gas and to better secure all that was taken apart to install the intercoolers and piping. I would have posted earlier, but I had to spend some time with my kids and after a long day and short night -- I feel asleep. Ash and I were up till 3am and then got up at 7am to hit the dyno at 10am. Feel like I am in college cramming for an exam. enuff - here are the details( no water injection - weather conditions were similar to Saturday - only change is the Ash-spec intercoolers and 2.5 inch piping ) 1bar = 15psi 
1.1 bar 
1.2 bar 
1.3 bar 
1.4 bar 
The seat of pants feel is unreal - no additional lag and the car feels like its on "roids" or a shot of NOS. A must have purchase. Ash will run higher boost levels tomorrow and hopefully the gains we saw at the lower psi/ bar levels will keep increasing as the boost is turned higher. I don't think I am overlaying the wrong dyno's over each other ....but there is a small possibility since I didn't write down the data .... I have about 8 other dyno run files from today .. and I will show those later when I can verify what the psi / bar levels are. I am 100% sure that the 1 bar and the 1.3 bar runs are correct for a fact.
=============Sig begins here================ "Somebody give this man a medal. Arguing with kenny is like being in the special olympics" ....ENVYMYZ on November 01, 2005 at 11:59 PM " .. going back and forth with you on a stupid point is like watching a retarded kid double dribble in basketball, you get tired of calling foul all day" ... Slowninja(GT28RS Inconel Z) on October 03, 2005 at 8:43 AM "the only chips you know about are Doritos. =)" ...ZEngineer on June 11, 2005 at 4:23 PM "....These posts only serve to make you look even worse, its gotten so bad it even makes me look bad to reply to you...." maglito on January 22, 2005 at 3:11 AM "What, are you afraid that only a couple of good ones have rolled off the production lines and the rest are crap?? ... Its mechanics not the stockmarket." ... ZisLuv on May 03, 2004 at 6:12 PM Z32 Power.Com Dyno Z Post 1 Z Post 2 My Project Z View Me! |
Dyno update from today! AshSPec SMIC/ 2.5 inch early results - 
