Subject	Re: I see...yeah, I think it comes down to...
Posted by	90Z-NA (ATL) on November 04, 2005 at 11:34 AM
	This message has been viewed 23 times.
In Reply To	I see...yeah, I think it comes down to... posted by thumper300zx on November 03, 2005 at 09:44 PM
Message	I think the FSM has a bit about how to install it without removing the glass. Basically, you cut the lower lip off and urethane it in, just as you would the piece on the stop of the windshield. Just dig as much of the remaining crap out, put the urethane in, and then mash the mouding in.
Follow Ups	Where to get REAR HATCH moulding (not top peices)...just the - thumper300zx 18:11:17 11/03/05 dealer dosn't carry it? (n/m) - MarkA(NoVA) 18:30:42 11/03/05 Dealer should have them...or atleast order them for you - ZXRider(SoCal) 18:34:30 11/03/05 First off, it is a single piece...2nd, yes, the dealer has.. - thumper300zx 18:43:29 11/03/05 Sorry -- Rear hatch WINDOW MOULDING is what I need... (n/m) - thumper300zx 19:42:47 11/03/05 It is VERY hard to find A/M that fits correctly - Spddracer 20:19:45 11/03/05 The lower piece is what I want to replace...are you... - thumper300zx 20:37:06 11/03/05 Page bf=38? Shows how it sits in there - Spddracer 20:53:09 11/03/05 Is this the page you refer to? - thumper300zx 21:18:32 11/03/05 No... page bf-38 in the service manual. - Spddracer 21:22:05 11/03/05 I see...yeah, I think it comes down to... - thumper300zx 21:44:50 11/03/05 Re: I see...yeah, I think it comes down to... - 90Z-NA (ATL) 11:34:29 11/04/05
Post a Followup	You cannot reply to this message because you are not logged in.