Subject	I see...yeah, I think it comes down to...
Posted by	thumper300zx on November 03, 2005 at 9:44 PM
	This message has been viewed 26 times.
In Reply To	No... page bf-38 in the service manual. posted by Spddracer on November 03, 2005 at 09:22 PM
Message	how the glass gets centered and how much goop you get on that moulding. If the glass were poorly centered it would "squeeze" one side of the moulding and make it very difficult to remove, especially if the moulding is old an hard. Just so you know, my moulding is completely removed now...was quite easy to pull off. Either I will find an aftermarket or buy from COZ for 85 Frickin' $. -Dave Z's Rule!
Follow Ups	Where to get REAR HATCH moulding (not top peices)...just the - thumper300zx 18:11:17 11/03/05 dealer dosn't carry it? (n/m) - MarkA(NoVA) 18:30:42 11/03/05 Dealer should have them...or atleast order them for you - ZXRider(SoCal) 18:34:30 11/03/05 First off, it is a single piece...2nd, yes, the dealer has.. - thumper300zx 18:43:29 11/03/05 Sorry -- Rear hatch WINDOW MOULDING is what I need... (n/m) - thumper300zx 19:42:47 11/03/05 It is VERY hard to find A/M that fits correctly - Spddracer 20:19:45 11/03/05 The lower piece is what I want to replace...are you... - thumper300zx 20:37:06 11/03/05 Page bf=38? Shows how it sits in there - Spddracer 20:53:09 11/03/05 Is this the page you refer to? - thumper300zx 21:18:32 11/03/05 No... page bf-38 in the service manual. - Spddracer 21:22:05 11/03/05 I see...yeah, I think it comes down to... - thumper300zx 21:44:50 11/03/05 Re: I see...yeah, I think it comes down to... - 90Z-NA (ATL) 11:34:29 11/04/05
Post a Followup	You cannot reply to this message because you are not logged in.