Subject	It is VERY hard to find A/M that fits correctly
Posted by	Spddracer on November 03, 2005 at 8:19 PM
	This message has been viewed 30 times.
In Reply To	Sorry -- Rear hatch WINDOW MOULDING is what I need... (n/m) posted by thumper300zx on November 03, 2005 at 07:42 PM
Message	That seal slides over the edge of the glass and then the glass is set in the hatch. The A/M doesnt fit worth a shit. There are 2 pieces also. The lower piece that runs from the edge of the top around the bottom and back up. Then the other piece goes across the top. The top piece is REALLY expensive like over $100 I believe. It has a metal bracket on it that slides over the top of the hatch glass before its set in. To change either correclty the glass has to be removed. Make sure it doesn't get broken in the process.
Follow Ups	Where to get REAR HATCH moulding (not top peices)...just the - thumper300zx 18:11:17 11/03/05 dealer dosn't carry it? (n/m) - MarkA(NoVA) 18:30:42 11/03/05 Dealer should have them...or atleast order them for you - ZXRider(SoCal) 18:34:30 11/03/05 First off, it is a single piece...2nd, yes, the dealer has.. - thumper300zx 18:43:29 11/03/05 Sorry -- Rear hatch WINDOW MOULDING is what I need... (n/m) - thumper300zx 19:42:47 11/03/05 It is VERY hard to find A/M that fits correctly - Spddracer 20:19:45 11/03/05 The lower piece is what I want to replace...are you... - thumper300zx 20:37:06 11/03/05 Page bf=38? Shows how it sits in there - Spddracer 20:53:09 11/03/05 Is this the page you refer to? - thumper300zx 21:18:32 11/03/05 No... page bf-38 in the service manual. - Spddracer 21:22:05 11/03/05 I see...yeah, I think it comes down to... - thumper300zx 21:44:50 11/03/05 Re: I see...yeah, I think it comes down to... - 90Z-NA (ATL) 11:34:29 11/04/05
Post a Followup	You cannot reply to this message because you are not logged in.