 |

  |
 |
| |
|
|
| Subject |
fyi; no one tunes at idle. i've never seen an A/F ratio |
 |
| |
|
|
| Posted by |
ni[X]it on November 01, 2005 at 5:10 PM |
 |
| |
This message has been viewed 130 times. |
 |
| |
|
|
| In Reply To |
Collection of dynocharts >> posted by Ash's Z on November 01, 2005 at 03:48 PM |
 |
| |
|
|
| Message |
post showing killer idle A/F ratio. not a single dyno chart will show this, as 99% start at 2,000rpm, or even more. I've even tried tuning for part throttle/low RPM on a mustang brand dyno... but since the dyno couldn't load the car, the results where erroneous at best.Tuning drivability is a whole other bag of beans, and should not be brought up as a dyno only tuning venture. WOT tuning does not make the package complete. I'm not siding anywhere here. Just stating the facts. Ps, I plan to enter your timing values into one of my other programs that will tell me how off your chart may be. or on. I know for sure, I'm throwing +45 degrees out max, while you're only doing 40 degrees, so thats not too agressive IMHO. I need to see it tho... as a 3D chart. Numbers suxor.
Petz #3
|
 |
| |
|
|
| Follow Ups |
|
|
| |
|
|
Post a Followup |
You cannot reply to this message because you are not logged in.
|
|
| |
|
|
| |
|
|
|