Subject	NZR but topic related question
Posted by	dogpile on November 01, 2005 at 8:52 AM
	This message has been viewed 22 times.
In Reply To	GTBB Oil Line Kits Ready posted by Seb (Specialty-Z) on October 31, 2005 at 08:32 PM
Message	when i go to put on my ball bearing t3 would i need to use a restrictor? the reason i ask is that fm uses the gt28rls bb turbo in its kits but doesnt use a restrictor. ss line, yes, but it just screws into the turbo. i ahvent noticed any oil loss/consumption with the old setup thanks
Follow Ups	GTBB Oil Line Kits Ready - Seb (Specialty-Z) 20:32:30 10/31/05 Was that a probe on the passenger side turbo? - KaZ (VaBch) 21:13:53 10/31/05 Correct (n/m) - Seb (Specialty-Z) 21:17:20 10/31/05 hehe sweeet just in time :) (n/m) - CollegeBoy 21:15:12 10/31/05 Nice. Those look just like the lines I used on my engine - Ash's Z 21:27:11 10/31/05 Re: Nice. Those look just like the lines I used on my engin - Seb (Specialty-Z) 21:31:02 10/31/05 ;-) Rock on! (n/m) - Ash's Z 21:35:04 10/31/05 That FRAM filter was just a place holder right? - KaZ (VaBch) 08:24:46 11/01/05 Good work, will add to my list to purchase. Will contact - dregos 21:54:46 10/31/05 Looks great, can't wait to get mine! - maglito 23:57:35 10/31/05 Re: Looks great, can't wait to get mine! - Seb (Specialty-Z) 00:24:27 11/01/05 awesome thanks! - maglito 01:36:44 11/01/05 Is there a reason stock lines couldn't be used w. the newer - YugoBernie (NoVA) 01:24:27 11/01/05 Yes... - KaZ (VaBch) 08:23:08 11/01/05 you could use a tube bender to reshape the lines to - Atl300zxTT (Less Lazy) 10:00:59 11/01/05 Re: you could use a tube bender to reshape the lines to - Seb (Specialty-Z) 10:29:52 11/01/05 NZR but topic related question - dogpile 08:52:02 11/01/05 Re: NZR but topic related question - Seb (Specialty-Z) 10:28:14 11/01/05 thanks. makes me think even higher of their kits - dogpile 13:06:10 11/01/05 You have a banjo fitting in the kit picture. Where does - AzHeat 13:06:59 11/01/05 Re: You have a banjo fitting in the kit picture. Where does - Seb (Specialty-Z) 13:32:22 11/01/05 Did you put silicone on the threads? Why not teflon tape? (n/m) - AzHeat 16:47:22 11/01/05
Post a Followup	You cannot reply to this message because you are not logged in.