Subject	GTBB Oil Line Kits Ready
Posted by	Seb (Specialty-Z) on October 31, 2005 at 8:32 PM
	This message has been viewed 607 times.
Message	Ok guys they are finally available for sale now, check classifieds. A must have for anyone upgrading to ballbearing turbochargers. Turbos in general require less oil pressure and ballbearing turbos require even less! After using stock lines on some bb setups we would get slight oil consumption and at times it was noticeable via the exhaust. The kit comes with the lines and fittings required, and completely replace the stock feed lines. Basic instructions are included with the kit. Click To Go To The Specialty-Z Website
Follow Ups	GTBB Oil Line Kits Ready - Seb (Specialty-Z) 20:32:30 10/31/05 Was that a probe on the passenger side turbo? - KaZ (VaBch) 21:13:53 10/31/05 Correct (n/m) - Seb (Specialty-Z) 21:17:20 10/31/05 hehe sweeet just in time :) (n/m) - CollegeBoy 21:15:12 10/31/05 Nice. Those look just like the lines I used on my engine - Ash's Z 21:27:11 10/31/05 Re: Nice. Those look just like the lines I used on my engin - Seb (Specialty-Z) 21:31:02 10/31/05 ;-) Rock on! (n/m) - Ash's Z 21:35:04 10/31/05 That FRAM filter was just a place holder right? - KaZ (VaBch) 08:24:46 11/01/05 Good work, will add to my list to purchase. Will contact - dregos 21:54:46 10/31/05 Looks great, can't wait to get mine! - maglito 23:57:35 10/31/05 Re: Looks great, can't wait to get mine! - Seb (Specialty-Z) 00:24:27 11/01/05 awesome thanks! - maglito 01:36:44 11/01/05 Is there a reason stock lines couldn't be used w. the newer - YugoBernie (NoVA) 01:24:27 11/01/05 Yes... - KaZ (VaBch) 08:23:08 11/01/05 you could use a tube bender to reshape the lines to - Atl300zxTT (Less Lazy) 10:00:59 11/01/05 Re: you could use a tube bender to reshape the lines to - Seb (Specialty-Z) 10:29:52 11/01/05 NZR but topic related question - dogpile 08:52:02 11/01/05 Re: NZR but topic related question - Seb (Specialty-Z) 10:28:14 11/01/05 thanks. makes me think even higher of their kits - dogpile 13:06:10 11/01/05 You have a banjo fitting in the kit picture. Where does - AzHeat 13:06:59 11/01/05 Re: You have a banjo fitting in the kit picture. Where does - Seb (Specialty-Z) 13:32:22 11/01/05 Did you put silicone on the threads? Why not teflon tape? (n/m) - AzHeat 16:47:22 11/01/05
Post a Followup	You cannot reply to this message because you are not logged in.