TwinTurbo.NET: Nissan 300ZX forum - Procedure we use several times a week to break in new motors
People Seeking Info
 
   


     
Subject Procedure we use several times a week to break in new motors
     
Posted by Russell@Z1 on October 27, 2005 at 8:38 PM
  This message has been viewed 159 times.
     
In Reply To What do Greg/Kyle/Z1 currently do with new builds? (n/m) posted by dpjax on October 27, 2005 at 08:03 PM
     
Message 20-30 minutes at idle and light revs after initial start-up
Oil change #1
Go drive car ~100 miles staying out of boost.
oil change #2
Strap car to dyno
Perform a series of dyno pulls increasing throttle and boost allowing cool down periods between pulls. Eventually ending up at full power runs. Dyno still does not put as much stress on engine as the street.
oil change #3

Drive car another 100 miles or so at moderate boost.
Check over and under

Return to customer and tell them to take it easy for another 500 miles or so and do an oil change with synthetic at 1000 miles.

We've broken serveral of our own cars in on the dyno right from the start and they have done fine. We just try to take a more middle of the road approach with customers cars.

Russell Floyd

Z1 Motorsports
www.z1motorsports.com
1990+ Nissan Z specialists

Used Parts, New parts, Service/Repair and Performance

1200 Carrollton Hwy
Temple, Ga 30179

770-562-8668
770-562-8664 (fax)

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.