Subject	I was being sarcastic. Stock bushings are pre-loaded
Posted by	Guapo on October 20, 2005 at 3:45 PM
	This message has been viewed 33 times.
In Reply To	Thanks guapo (n/m) posted by 300ZMang on October 20, 2005 at 03:38 PM
Message	with silicone. Once they leak, time to replace them. You cannot "refill" them. IMO, you should just go with ES bushings. I believe there is a new design that adresses the control arm issue. Petz #2 "What's the point of having the car if you don't drive it?" - Mrs. Guapo 08/20/05 Jeeeesus Christ - my Dad (after a ride in my Z) 12/26/04
Follow Ups	Good Ol' Tension Rods.... - 300ZMang 15:16:26 10/20/05 yeah ... inject them with some silicone to keep them fresh (n/m) - Guapo 15:23:36 10/20/05 *botox (n/m) - whitepearlz 15:28:08 10/20/05 Thanks guapo (n/m) - 300ZMang 15:38:41 10/20/05 I was being sarcastic. Stock bushings are pre-loaded - Guapo 15:45:32 10/20/05 Correct, apparently they have replaced the problem. (n/m) - whitepearlz 16:00:08 10/20/05 Don't they make urethane bushings for the t-rod? (n/m) - chenc544 15:27:16 10/20/05 Well yea, they have aftermarket bushings - 300ZMang 15:36:22 10/20/05 Yes, the ES ones will cause control arms to crack - s3trios 15:39:19 10/20/05 ES ones "may" cause control arms to crack. (n/m) - Woody75 (Denver) 15:59:04 10/20/05 big difference, but enough of a chance to warrant new design (n/m) - Zrevolver 16:45:24 10/20/05 Get nizmo bushings. (n/m) - Spddracer 17:08:50 10/20/05 So i guess you got them? (n/m) - MyWhiteZTT(NJ) 20:10:03 10/20/05 Affirmative Captin (n/m) - 300ZMang 21:51:13 10/20/05
Post a Followup	You cannot reply to this message because you are not logged in.