TwinTurbo.NET: Nissan 300ZX forum - u obviously didn't read .. I asked for names ??? and
People Seeking Info
 
   


     
Subject u obviously didn't read .. I asked for names ??? and
     
Posted by Slowninja(GT28RS Inconel Z) on October 02, 2005 at 3:47 PM
  This message has been viewed 46 times.
     
In Reply To wow. a few vac lines swapped, bad plugs and boost leaks.. posted by Halo Z on October 02, 2005 at 03:34 PM
     
Message there was alot more work than what u mentioned / afc was wired incorrectly / air filters did not allow the air to meter correctly / egr lines mixed up /afc setup configuration for dual mas / in addition to the points u mentioned earlier .. like I said who (of the posters today) would have figured all this out in one day ??? U still haven't answered that question. Could you have done it ?

=============Sig begins here================

"the only chips you know about are Doritos. =)" ...ZEngineer on June 11, 2005 at 4:23 PM

"... Installing the ES bushing was a huge pain for me because it's so stiff. I like the way it feels once installed, but if I had to do it over again, I'd get the OEM ... it's soft enough to flex right into place ".... 300ZMang on May 05, 2005 at 10:47 AM

"What, are you afraid that only a couple of good ones have rolled off the production lines and the rest are crap?? ... Its mechanics not the stockmarket." ... ZisLuv on May 03, 2004 at 6:12 PM

"....I think you need to lay off the sauce or whatever you have driving you nuts and take it easy for a while. These posts only serve to make you look even worse, its gotten so bad it even makes me look bad to reply to you...." maglito on January 22, 2005 at 3:11 AM


"You think when you go to a bar with your girlfriend, every other guy there is gonna be your best friend? Welcome to reality." ........ dilo on January 04, 2005 at 4:02 PM

Z32 Power.Com


pump fuel :
519 rwhp / 502 torque

sunoco 104 race fuel :
604 rwhp / 544 torque

Dyno Charts -

Dyno

Z Post 2

Z Post 1

My Project Z

View Me!

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.