TwinTurbo.NET: Nissan 300ZX forum - eBay UD Pulleys, are they that bad...
People Seeking Info
 
   


     
Subject eBay UD Pulleys, are they that bad...
     
Posted by SkiFly01 on September 29, 2005 at 6:16 PM
  This message has been viewed 392 times.
     
     
Message Well, today I was doing some work on the TT and I was reminded of the post that was posted from Z1. Basically they found that they had motor issues due to the eBay pulleys not having a timing mark or that they were off a few degrees. I decided to check my eBay pulley that has a timing mark. Guess what, I found out that the mark that was on the pulley was retarded behind the OEM marking by about 2~3 degrees. So I made a new mark and will use that now. It was fairly easy to verify, just set the OEM pulley on a mark, pull it off and install the UD pulley and put a new mark on it. I marked it with a marker then later used a hammer and screw driver for a more permanent marking.


eBay UD pulley timing mark

Kai

Now a member of the Dark Side

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.