Subject	Thank you! you are so very helpful. Thanks again (n/m)
Posted by	Jaspec on September 15, 2005 at 8:26 PM
	This message has been viewed 12 times.
In Reply To	put caps where the 2 hoses for the recircs go into the pipes (n/m) posted by boileralum on September 15, 2005 at 04:33 PM
Message
Follow Ups	Hard Pipe kit with bov mount's - booster 15:03:29 09/15/05 you can adjust the apexi's so they dont hit - genic 15:06:45 09/15/05 APEX BOVs used with dual pop here, no interference - ZEngineer 15:18:03 09/15/05 Is HKS Hard pipe has one? I need to know (n/m) - Jaspec 15:19:52 09/15/05 No. HKS hard pipes must be custom welded - Joe(NoVA) 15:28:55 09/15/05 it's not that big of a deal - they sell the flanges - boileralum 15:32:41 09/15/05 It turns into a huge deal when they screw them up - Joe(NoVA) 15:40:32 09/15/05 cosmetics - blah ;-) (n/m) - boileralum 15:51:42 09/15/05 Mine don't fit right, i ended up having to buy scott's (n/m) - Joe(NoVA) 16:01:38 09/15/05 His look nicer anyways :-) (n/m) - WickedZX (NoVA) 16:07:58 09/15/05 Go to ATP turbo.com. They sell the flanges there I believe - Shawn300zTT GT28R MD 17:08:10 09/15/05 Hey man, is there any write up on doing this? - Jaspec 15:51:01 09/15/05 not that I know of, but if I were doing them, I'd buy - boileralum 15:53:24 09/15/05 *taking notes. - Jaspec 16:01:14 09/15/05 put caps where the 2 hoses for the recircs go into the pipes (n/m) - boileralum 16:33:02 09/15/05 Thank you! you are so very helpful. Thanks again (n/m) - Jaspec 20:26:07 09/15/05 That's EXACTLY what I did. Mine turned out fine. (n/m) - whitepearlz 17:27:40 09/15/05 Me too... my welder just didn't put them where i said to (n/m) - Joe(NoVA) 09:38:06 09/16/05
Post a Followup	You cannot reply to this message because you are not logged in.