Subject	not that I know of, but if I were doing them, I'd buy
Posted by	boileralum on September 15, 2005 at 3:53 PM
	This message has been viewed 17 times.
In Reply To	Hey man, is there any write up on doing this? posted by Jaspec on September 15, 2005 at 03:51 PM
Message	the flanges, mount them to the BOVs, then test-fit multiple times to figure out where the flanges need to go on the hardpipes while everything is mocked up in the car. Then mark the pipes, take them off and take them to your local welder. Rule #1 - There's always a bastard! JRH(KY): for some reason, when I hear the word 'tranny' I think of transvestite before I do transmission. don't ask me why boileralum: FAGMO! ----------------------------------------- Bill (ImTheDevil): blah blah blah me: Just because you are covered in gasoline right now, doesn't mean you are right! ----------------------------------------- JRH (KY): I'm also using up a weekend this month for Indy and a weekend next month for the USGP. Throw in our trip to PA and GF is getting tired of my car habit. Boy I'm going to miss her :-D
Follow Ups	Hard Pipe kit with bov mount's - booster 15:03:29 09/15/05 you can adjust the apexi's so they dont hit - genic 15:06:45 09/15/05 APEX BOVs used with dual pop here, no interference - ZEngineer 15:18:03 09/15/05 Is HKS Hard pipe has one? I need to know (n/m) - Jaspec 15:19:52 09/15/05 No. HKS hard pipes must be custom welded - Joe(NoVA) 15:28:55 09/15/05 it's not that big of a deal - they sell the flanges - boileralum 15:32:41 09/15/05 It turns into a huge deal when they screw them up - Joe(NoVA) 15:40:32 09/15/05 cosmetics - blah ;-) (n/m) - boileralum 15:51:42 09/15/05 Mine don't fit right, i ended up having to buy scott's (n/m) - Joe(NoVA) 16:01:38 09/15/05 His look nicer anyways :-) (n/m) - WickedZX (NoVA) 16:07:58 09/15/05 Go to ATP turbo.com. They sell the flanges there I believe - Shawn300zTT GT28R MD 17:08:10 09/15/05 Hey man, is there any write up on doing this? - Jaspec 15:51:01 09/15/05 not that I know of, but if I were doing them, I'd buy - boileralum 15:53:24 09/15/05 *taking notes. - Jaspec 16:01:14 09/15/05 put caps where the 2 hoses for the recircs go into the pipes (n/m) - boileralum 16:33:02 09/15/05 Thank you! you are so very helpful. Thanks again (n/m) - Jaspec 20:26:07 09/15/05 That's EXACTLY what I did. Mine turned out fine. (n/m) - whitepearlz 17:27:40 09/15/05 Me too... my welder just didn't put them where i said to (n/m) - Joe(NoVA) 09:38:06 09/16/05
Post a Followup	You cannot reply to this message because you are not logged in.