Subject	Injector Test and Cleaning....
Posted by	300ZMang on September 13, 2005 at 1:54 PM
	This message has been viewed 121 times.
Message	I have a spare engine I plan on dismantling to utilize the injectors. I'm going to mate those 6 with my current 6 to make the "best" 6 for my car. If I Ohm test these, and they show within spec, that's no gaurantee that they will flow/spray as they should. What would you guys recommend doing to them prior to installation to make them as efficient and productive as possible ?? If you say ship them to have them flow tested etc where is a good shop ? I'm in CT so obviously the closer the better. TIA
Follow Ups	Injector Test and Cleaning.... - 300ZMang 13:54:00 09/13/05 I think most will recommend RC Engineering for your - whitepearlz 14:02:02 09/13/05 2nd - Ricerdaddy 15:15:54 09/13/05 3rd - RedSER13 15:18:14 09/13/05 Well I dunno about that then, bc Im going to only - 300ZMang 15:40:14 09/13/05 test all, keep best 6, sell the rest. (n/m) - SactoTodd 15:49:30 09/13/05 witchhunter.com - dogpile 21:18:38 09/13/05 sorry, just over half price - dogpile 21:42:49 09/13/05 I'll check it out, thanks (n/m) - 300ZMang 21:51:42 09/13/05
Post a Followup	You cannot reply to this message because you are not logged in.