Subject	Stroker kits
Posted by	ZisLuv on September 01, 2005 at 9:43 PM
	This message has been viewed 145 times.
Message	Just wondering if anyone has experience with these? I know about the JUN kit but way overpriced. Was wondering if anyone has used the Paeco kit? Obviously their crank isnt forged so does anyone else think this would have problems handling say 650rwhp? I was reading through search and Z from Japan was going to try a bore and stroke up to 3.5L. Anyone else give this any serious consideration or know if he actually did it? Lastly, everyone says it will affect your ability to rev, but anyone actually know by how much? Would this effect even be noticeable? Thanks.
Follow Ups	Stroker kits - ZisLuv 21:43:26 09/01/05 I have a Paeco stroker motor sitting in my garage. - Woody75 (Denver) 21:58:37 09/01/05 Funny you should bring that up. I recently visited JWT - SirpriZ 22:56:06 09/01/05 Re: Funny you should bring that up. I recently visited JWT - Pacmanpth 23:43:49 09/01/05 This is an extra step after the forging of the crank to - SirpriZ 23:46:42 09/01/05 Re: Stroker kits - nend 02:19:53 09/02/05 So it just affects top rpm or is it slower to rev? (n/m) - ZisLuv 04:41:27 09/02/05 Re: So it just affects top rpm or is it slower to rev? - nend 06:58:07 09/02/05 I would stay far away from Paeco stuff - Russell@Z1 08:07:06 09/02/05 IMO, JUN isnt worth the bucks for a street car - WAGGZ 10:41:05 09/02/05
Post a Followup	You cannot reply to this message because you are not logged in.