| For those that are interested in the dual fuel pump setup -- all the parts ( 95%) are in my profile . Later I will post more pics of the Fuel Pump Controller and some of the stainless steel routing and plumbing in the motor area. Rear shot with Amp cover 
Up close - u can see the amp 
Rear view seen outside of the car of the amp 
Some of the wiring of the second pump ( power and ground can be seen from top left. This goes down to the second fuel pump controller 
Second fuel line and fittings ( stainless steel with 90degree elbow and fittings. Power wire and Ground wire and elbow tap through the fuel pump bulkhead. Holes were drilled into the fuel pump bulkhead cover ( removed from fuel pump first to prevent sparks / explosion )
Fuel pump comes out. Two walbros side by side with 1ft fuel line ( cut to fit ) connected to fittings for 90 degree elbow. You can also see how the power wire and ground are connected to the second walbro pump. I also suggest to use WD40 or some type of lubricant on the fuel level sendor. Mine began sticking and hence - I pulled the pumps out to determine what was going on. After 150k miles on a 13 year old car, parts will begin to need some lubrication I guess! 
Reverse side of the pumps 
Re-install of dual fuel pumps. You need to compress the fuel lines a little for the two pumps to drop into the tank. 
FYI: When drilling holes in the bulkhead, make sure to use some type of gas sealant or you will smell gas fumes all day.
More pics of the of things to come later ...
=============Sig begins here================
"the only chips you know about are Doritos. =)" ...ZEngineer on June 11, 2005 at 4:23 PM "... Installing the ES bushing was a huge pain for me because it's so stiff. I like the way it feels once installed, but if I had to do it over again, I'd get the OEM ... it's soft enough to flex right into place ".... 300ZMang on May 05, 2005 at 10:47 AM "What, are you afraid that only a couple of good ones have rolled off the production lines and the rest are crap?? ... Its mechanics not the stockmarket." ... ZisLuv on May 03, 2004 at 6:12 PM "....I think you need to lay off the sauce or whatever you have driving you nuts and take it easy for a while. These posts only serve to make you look even worse, its gotten so bad it even makes me look bad to reply to you...." maglito on January 22, 2005 at 3:11 AM
"You think when you go to a bar with your girlfriend, every other guy there is gonna be your best friend? Welcome to reality." ........ dilo on January 04, 2005 at 4:02 PM
Z32 Power.Com
pump fuel :
519 rwhp / 502 torque
sunoco 104 race fuel :
604 rwhp / 544 torque Dyno Charts - Dyno La-Z-Link La-Z-Link
|
pics of Dual Fuel Pump install (part 1) - 
