TwinTurbo.NET: Nissan 300ZX forum - yep
People Seeking Info
 
   


     
Subject yep
     
Posted by aliaZ on August 27, 2005 at 9:25 PM
  This message has been viewed 71 times.
     
In Reply To What needs to happen is>>>>>> posted by Seb (Specialty-Z) on August 27, 2005 at 09:00 PM
     
Message
If you look at the low lift flow data from the texas heads, they out flow the heads that Mike used for his baseline. This isn't an entirely apples to apples comparison, but if Mike had used the Texas heads the numbers likely would have been even better.

Mike's heads were bone stock, the texas heads were not (3 angle valve job).

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.